|
|
|
tags : HT, Alinco, DJ, 496, Handy Talky, Radio Komunikasi
Handy Talky atau HT Alinco DJ 496 UHF Alinco has created a new UHF FM Hand held Transceiver that sets new standards in features, convenience and easy operation. The DJ-496T sports an alphanumeric display for easy memory management. It has an ergonomic design that's "user friendly" and the 4 watt output battery is standard. You'll be ready to travel the world with CTCSS encode+decode, DCS and European tone bursts, all included at no extra cost. Best of all, the DJ-496T retains the proud Alinco tradition of quality construction and excellent value.
• Alphanumeric display
• 40 memory channels + Call Channel
• Backlit Keypad
• 4 watt output with standard battery
• CTCSS encode+decode and DCS
• 13.8 VDC direct input with battery charge feature
• Direct frequency input
• S-meter
• Autodialer
• Cable Cloning
• Computer programmable (third party software required)
• MARS/CAP capability
• Additional features, including theft alarm! | Alphanumeric Display | Label channels in an easy-reading format. Display frequency, alpha label or channel number only. | | 40 Memory Channels + Call Channel | Plenty of room to store your favorite simplex or repeater frequencies along with alphanumeric label, offset, CTCSS encode/decode or DCS setting. | | 4 watts output | The standard battery allows the DJ-496T to produce up to 4 watts. A power input port Accepts 13.8 VDC and charges the battery, but won't allow destructive overcharge. | | CTCSS, DCS, Tone Bursts and DTMF | Be prepared for virtually any selective calling situation or gaining access to repeaters with protected inputs. European Tone Bursts include 1000, 1450, 1750 and 2100 Hz. | | Direct Frequency Input | Frequency entry is easy using the well-spaced keypad. | | S-Meter | Displays relative signal strength. | | Cable Cloning | Share identical settings among multiple DJ-496T transceivers. Saves time and ensures uniform operation. | | Theft Alarm | The DJ-496T can be set to emit a tone when disconnected from an external power source until proper action is taken to silence the alarm. | | Experimental Insect Repel Feature | Can the DJ-496T actually repel mosquitoes? Activate the special tone and decide for yourself! You may find the DJ-496T can "de-bug" your outdoor operating site! |
SPECIFICATIONS
| | | General | DJ-496T | | Freq. RX original status | 430 to 449.995 MHz | | Freq. Stability | +/-5 ppm | | Antenna Imp. | 50 ohm unbalanced | | Supply Voltage | DC 13.8V rated | | | DC 7.0min to 16V max | | Ground | Negative GND | | Current consumption | TX 5W 1.4A approx. | | at 13.8V external source | RX 200mA approx/280mW | | | RX squelched 50mA approx. | | | RX Batt.Save on 20mA approx. | | Operating Temp. range | -10 to +60 degrees C. | | Dimention w/o projection | 56(W) x 124(H) x 40 (D) | | Weight with EBP-48N | Approx. 375g (13.2oz) | | Transmitter | | | Output power | 5W 13.8V or 4W EBP-48N | | | Low=0.8W | | Modulation | Variable reactance FM | | Max. Deviation | +/- 5kHz | | Spurious emission | less than -60db | | Microphone Imp. | 2k ohms approx. | | | | | Receiver | | | Circuit | Double superheterodyne | | 1st IF freq. | 45.1Mhz | | 2nd IF freq. | 455khz | | | | | Sensitivity 12db SINAD | better than -12dBu | | | (0.25uV or less) | | | | | | | | Selectivity | more than -6dB/12kHz | | | less than -60dB/26kHz | | Audio output power | 280mW | | Audio impedance | 8 ohms | | | |
|
|
|
